Each group needs to design its own circuitry to wire the electric radiators to the power supplied to the garage: Circuit Analysis Assignment, CUCST, Malaysia

Task 1

Each group needs to design its own circuitry to wire the electric radiators to the power supplied to the garage. The circuit is expected to supply total power of 2000 W with a tolerance of ± 3% and should have the following components:

• At least 1 independent voltage source
• At least 1 independent current source
• At least 6 resistors in series and parallel configurations
• At least 1 dependent voltage/current source
• The circuit has at least 3 meshes.

In order to complete the task,

1. From your own circuitry, simulate the circuit using any simulation tools in order to obtain the voltage and current for each element.
2. Perform circuit analysis using both Node Voltage AND Mesh-Current Methods.
3. Compare and discuss the calculated and simulated results.
4. Prove that your circuit is balanced.

Task 2

The track on the printed circuit board (PCB) can be represented as a circuit element of an inductor, resistor, and capacitor in an RLC circuit configuration. Build your own RLC circuit using component values from Table 1 if the source voltage of the track is given as VS = 40 cos 5,000t V.

Answer

Request Answer of this Assignment